1
2
3
4
5
6
1 2
3
[ 40 ] [ 41 ]
NOTE: Primary Hub will be listed with all
secondary Hubs nested underneath in
a collapsible list. To access a secondary
Hub’s information, including to rename
it, simply select from this list.
NOTE: When fully configured, the
Hub LED will turn solid green.
Hub Setup: Wireless
The WiFi capability of the PowerView® Hub allows it to be placed to a more convenient location
within the home without needing to be tethered to a router.
Complete the Wired Setup on page 39 PRIOR to beginning the following steps.
Go to MENU.
SELECT Hub WiFi Setup.
SELECT Hub.
SELECT Hub Info.
Follow configure sequence as
instructed in App.
Secondary Hub Setup: Wired
A secondary Hub may be introduced to your PowerView® network to extend the reach and strength of the
network. Naturally, a secondary Hub is any Hub that is setup after a first, ie. primary, Hub has established a
PowerView® network. A primary Hub will be identified by its solid blue LED. Any secondary Hub will be identified
by its solid green LED. The primary Hub should be connected to power and its LED should be solid blue before
setting up a secondary Hub.
CONNECT secondary Hub to: A) Ethernet then B) Power.
In App, OPEN Menu. SELECT Hub.
The Hub will automatically configure
as a secondary Hub.
NOTE: Allow Hub to
automatically seek,
retrieve, and install
firmware update.
Hub LED sequence
will go from blinking
aqua, to solid amber,
to blinking amber.
Do not interrupt
this process. After
installing the
firmware update,
Hub will reboot.
Firmware update
process may take
several minutes.
A
A
B
B
To Next Page
Loading...
Need help?
General
