NOTE: Deselected/inactive
Group numbers are not
illuminated.
NOTE: Selected/active Group
number(s) (1-6) are illuminated.
5
[ 8 ] [ 9 ]
Duplicating a Remote
Duplicating a remote copies a remote’s unique Group programming information and transfers it to
another remote so that they are essentially identical. Window coverings programmed to operate
with one remote will also respond to commands from a duplicated remote. Duplicating a remote
is not the same as pairing multiple remotes to a PowerView® Shade Network.
Source
Target
NOTE: Group number (1-6) buttons
will flash twice on the initial press
of Reset button, then again at six
seconds. Target remote now ready
to receive information from source
remote.
Target
Source
Target
NOTE: The source
remote is the remote
to be duplicated. The
target remote is the
remote that receives
the source remote’s
Group programming
information.
4
2
3
1
Using a paper clip, PRESS and HOLD
recessed Reset button on back of
target remote for 6-10 seconds. If
necessary, remove back cover.
Simultaneously. . .
PRESS and RELEASE n(Stop) on source
remote. RELEASE All on target remote.
PRESS and HOLD All on target
remote.
On source remote, PRESS and HOLD
n(Stop) until indicator lights begin
to blink. Source remote is now in
Programming Mode.
SELECT the source remote. SELECT the target remote.
NOTE: The Group numbers (1-6) on
the target remote will flash twice. This
indicates that the source remote’s
Group programming information has
been duplicated and transferred to
the target remote. Both remotes are
now identical.
1
1
PRESS and RELEASE desired Group
number(s) (1-6)
PRESS and RELEASE desired Group
number(s) (1-6).
Selecting & De-selecting Groups
Before operating a single window covering you must first select its corresponding Group number (1-6) or the ALL
button. Multiple Group numbers can be selected for simultaneous operation in any combination. Group numbers
can be selected or deselected. Like any Group number, the ALL button can also be selected or deselected;
however, its selection will override any active Group(s).
Selecting a Group
De-selecting a Group
To Next Page
Loading...
Need help?
General
