15 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: LS002G
Blade diameter 216 mm
15.88 mm / 25.4 mm / 30 mm
Max. kerf thickness of the saw blade 2.4 mm
Max. miter angle Left 60°, Right 60°
Max. bevel angle Left 48°, Right 48°
No load speed 4,800 min
-1
Dimensions (L x W x H) 702 mm x 551 mm x 557 mm
Rated voltage D.C. 36 V - 40 V max
Net weight 16.4 - 17.0 kg
without notice.
-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge BL4020 / BL4025* / BL4040* / BL4050F*
* : Recommended battery
Charger DC40RA / DC40RB / DC40RC
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
Cutting capacities (H x W) with blade 216 mm in diameter
Miter angle Bevel angle
45° (left) 0° 45° (right)
0° 50 mm x 312 mm 70 mm x 312 mm 30 mm x 312 mm
45° (left and right) 50 mm x 220 mm 70 mm x 220 mm 30 mm x 220 mm
60° (left and right) – 70 mm x 155 mm –
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
-
riage fully and press down handle, then
push carriage toward the guide fence.
grip dial and tilt the carriage to the desired
angle, then tighten the grip dial.
When tilting the blade beyond the range 0°
- 45°, turn the releasing lever for 48° bevel
angle in clockwise direction.
blade.
Wear safety glasses.
Do not stare at operating lamp.
To Next Page
Loading...
Need help?
General
