Swing-away lattice
3.4 Description of the rigging work
3 - 76 3 112 441 en Lattice extension operating instructions
GMK 4100/4100-L/5095
11.01.2008
The button (1) is only active if the derricking swing-away lattice is connected
to the electrical power supply.
• Press the button (1) – the engine starts.
Pre-selecting derricking the swing-away lattice
• Press the button (1).
– The lamp in the button goes on.
Raising / lowering the swing-away lattice
• Press the button combination for the desired movement:
The further you press the button (1) or (2), the faster the movement is per-
formed.
The pre-selected movement is executed until you let go of the respective
button or until the respective end position has been reached.
1 raises the swing-away lattice
2 lowers the swing-away lattice
To Next Page
Loading...
Need help?
General
