Driving with rigged crane
8.4 Before driving with the rigged crane
Lattice extension operating instructions 3 112 441 en 8 - 3
GMK 4100/4100-L/5095
11.01.2008
8.4 Before driving with the rigged crane
• Check the tyre pressure and the wind speed; à Operating instructions of
the truck crane
.
• Switch off the slewing gear; à Operating instructions of the truck crane.
• Put the truck crane on the wheels; à Operating instructions of the truck
crane
. The suspension remains switched off.
• For reasons of safety, extend the outrigger beams as permitted by the
available space. The outrigger pads may not touch the ground while driv-
ing the crane.
8.5 Driving the rigged truck crane
Driving from the
driver's cab
• Switch to the lowest starting gear; à Operating instructions of the truck
crane
. In this way you can prevent the transmission from upshifting and
keep the speed to a minimum.
• Switch on the separate steering; à Operating instructions of the truck
crane
.
If necessary, you can
– Switch on the longitudinal differential locks
– Switch on the transverse differential locks
s
G
Risk of accidents when driving the truck crane from the driver's cab with a
raised load
Drive the truck crane with a raised load only from the crane cab. You must
be able to operate the crane at any time in the event of an emergency.
To Next Page
Loading...
Need help?
General
