Swing-away lattice
3.4 Description of the rigging work
3 - 78 3 112 441 en Lattice extension operating instructions
GMK 4100/4100-L/5095
11.01.2008
When derricking the swing-away lattice, the SLI automatically switches
fixed angles (0° inclination) and intermediate angles (0 – 20° or 20 – 40°
inclination) specified in the lifting capacity table if they are permitted for the
load currently raised.
If the switchover is not permitted for the load currently raised, derricking is
switched off and a corresponding error message is issued.
The swing-away lattice can be derricked under load. The derricking load
is limited;
à Lifting capacity table. Lowering is switched off if the limit is
exceeded.
Switching off the derricking gear
• Press the button (1) once.
– The lamp in the button (1) shines dimly.
– The symbol (2) is (red) if the derricking gear is switched off.
All power units are switched off and the lamps in the corresponding buttons
shine only dimly after turning off the ignition.
To Next Page
Loading...
Need help?
General
