39
CHAPTER 8: TROUBLESHOOTING
8.4 ERROR MESSAGES ON THE CONSOLE
ERROR CODE DESCRIPTION
0x01A2 Incline direction is reversed.
0x01A0 Incline motor is disconnected.
0x0140 Incline is stalled.
0x01A1 Calibration on the incline motor has failed.
0x02A0 Speed is commanded but no belt movement detected (could be missing magnet).
0x02AE Checksum failure on critical NOVRAM loading.
0x02AF Checksum failure on non-critical NOVRAM loading.
0x029F Error (Drive Fault Report) created by the motor controller - only used for AC motors.
0x02B1 The emergency circuit on the interface board failed.
0x02B2 The emergency circuit on the interface board active.
0x04A0 The console's communications is lost.
0x04A1 The motor controller board's communication is lost.
0x0441 Receives a command from the console with its correct packet, but the interface board
has no function to support it.
0x0442 The received command code from the console is correct and is supported, but it has less
or more data arguments.
0x0301 Flash or EEPROM error.
0x3A5 Failed to load program.
0x03A6 Failed to run program.
To Next Page
Loading...
Need help?
General
