Mercedes-Benz 2003 CLK 320 User Manual

102
Controls in detail
Memory function
Memory function
The memory button and stored position
switch are located on the door.
You can store up to three different settings
per SmartKey or SmartKey with KEY-
LESS-GO*.
The following settings are saved for each
stored position:
앫 Driver’s seat, backrest and restraint
position
앫 Settings for multicontour seat*
앫 Steering wheel position
앫 Driver’s side exterior rear view mirror
position
앫 Passenger side exterior rear view mir-
ror position
These key dependent memory settings can
be deactivated if desired (
컄 page 135).
1 Memory button
2 Stored position button
왘 Be sure that the ignition is switched on
or the relevant door is open and the
SmartKey is inserted in the starter
switch.
!
Prior to operating the vehicle, the driv-
er should check and adjust the seat
height, seat position fore and aft, and
seat backrest angle if necessary, to en-
sure adequate control, reach and com-
fort. The head restraint should also be
adjusted for proper height. Also see air-
bag section (
컄 page 57) for proper seat
positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, opera-
tion and comfort. Both the inside and
outside rear view mirrors should be ad-
justed for adequate rear vision.
Fasten seat belts. Infants and small
children should be seated in a properly
secured restraint system that complies
with U.S. Federal Motor Vehicle Safety
Standards 213 and 225 and Canadian
Motor Vehicle Safety Standards 213
and 210.2.
Warning! G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.

Mercedes-Benz 2003 CLK 320 Specifications

General

Brand	Mercedes-Benz
Model	2003 CLK 320
Category	Automobile
Language	English