R
entering a destination from the list of last
destinations
R
entering a special destination
R
entering a destination using the map
R
entering an intermediate stop
Entering adestination by address
i
In certain countries, it is notpossible to
enter an address if the vehicle is travelling
at more than approximately 5 km/h. As
soon as the vehicle speed drops below
about 3km/h, the function is available
again.
When entering an address as the destination,
you have the following options:
R
entering the country, town/postcode and
street
R
entering the country, town/postcode and
centre
R
entering the country, town/postcode,
street and number
R
entering the country, town/postcode,
street and junction
R
entering the country, town/postcode and
special destination
You can then start route calculation
(Y page 101).
Calling up the address input menu
X
Switch to navigation mode and display the
menu system (Y page 82).
X
Select DestinationQ Address entry.
The address inputmenu appears. It shows
the destination last used for starting route
calculation.
Address input menu
Menu items in the address input menu
Depending on the sequence in which you
enter the address and on the data status of
the digital map, some menu items may not be
available at all or may not yet be available.
Example:
After country selection, the Street, No.,
Centr. (centre), Junct. (junction), POI (spe-
cial destination), Save and Start menu items
are not yet available. In addition, the Post‐
code menu item will not be available if the
digital map does not contain any postcodes.
Selecting the country
i
You can only select countries that are
stored on the digital map.
X
Select Country in the address input menu.
You see the list of countries with the input
speller.
X
For the following operatingsteps:
Navigation system(entering adestination)
93
COMAND APS
BA 197 ECE RE 2010/6a; 1; 2, en-GB
sabbaeu Version: 3.0.3.6
2010-05-07T14:19:43+02:00 - Seite 93
Z
To Next Page
Loading...
Need help?
General
