Doc# 100576 • REV C (Sept 2017) Page 11 of 42
3.3 CONNECTING THE DPS TO A COMPUTER
Follow these steps to access the DPS USB connector for connecon to a computer.
3.3.1 REMOVE THE BASE
Remove the three screws from the DPS base to access the mini USB connector as shown in
Figure 7 and Figure 8.
Plug the USB A connector into an available USB port on your computer.
Remove these three screws to
remove the base
Plug the mini-USB connector
into the DPS Plug
To Next Page
Loading...
Need help?
General
