Doc# 100576 • REV C (Sept 2017) Page 4 of 42
1.3 RECEIVING, INSPECTING AND HANDLING THE SYSTEM
Metrix ships the probe, extension cable, and driver as separate units that the user intercon-
nects at the installaon site. Carefully remove all equipment from the shipping containers
and inspect it for shipping damage. If you see shipping damage, le a claim with the carrier
and submit a copy to Metrix Instrument Co. Include part numbers and serial numbers on all
correspondence. If no damage is apparent and the equipment is not going to be used imme-
diately, return the equipment to the shipping containers and reseal unl ready for use. Store
the equipment in an environment that is free from potenally damaging condions such as
extreme temperature, excessive humidity, or a corrosive atmosphere.
2. OVERVIEW
The Metrix Digital Proximity System module comes in two versions:
• MX2033 – 3-wire proximity driver
• MX2034 – 2-wire, loop powered proximity transmier
A complete DPS system requires a DPS module, a proximity probe, and an extension cable.
You can congure the MX2033 and MX2034 modules to operate with the probe and cable
combinaons shown in Table 1.
Metrix MX2030 5 mm or 8mm p 5m
Metrix MX2030 5 mm or 8 mm p 9 m
Metrix 7200 5 mm or 8 mm p 5 m
Metrix 7200 5 mm or 8 mm p 9 m
Bently Nevada 3300 or 3300 XL 5 mm or 8
mm p
5 m
Bently Nevada 3300 or 3300 XL 5 mm or 8
mm p
9 m
Bently Nevada 7200 5 mm or 8 mm p 5 m
Bently Nevada 7200 5 mm or 8 mm p 9 m
Standard target material is AISI 4140. Other materials available upon request.
To Next Page
Loading...
Need help?
General
