Need help?Do you have a question about the Metrix MX2034 and is the answer not in the manual?
General| Brand | Metrix |
|---|---|
| Model | MX2034 |
| Category | Measuring Instruments |
| Language | English |
Defines warning, caution, and note statements and symbols used in the manual.
Outlines key safety precautions to prevent injury and product damage during operation.
Instructions for safely receiving, inspecting for damage, and storing the system components.
Details the MX2033 as a 3-wire driver, its output signal, and API 670 compatibility.
Describes the MX2034 as a 2-wire transmitter with ISA standard 4-20 mA output for various measurements.
Lists additional documents for further information on DPS systems and datasheets.
Lists the necessary hardware and software components for configuring a DPS unit.
Step-by-step guide for installing the Metrix DPS Configuration and Utility Software on a computer.
Instructions on how to physically connect the DPS unit to a computer via USB for configuration.
How to start the installed DPS configuration software, typically by double-clicking its icon.
Overview of the main interface of the DPS Configuration Software and its primary sections.
Procedure to verify the voltage output scale factor of the DPS unit using specific test equipment.
Guide for performing custom calibration of the DPS to match specific probes and cables.
Lists common symptoms, possible problems, and recommended actions for MX2033 and MX2034 units.
Addresses specific troubleshooting symptoms, problems, and solutions exclusively for the MX2034 model.
Presents graphs showing the performance of DPS units under different temperature conditions.
Illustrates the expected phase shift error in relation to increasing measured frequency.
To Next Page
