Unpacking and installing
*INSTALLATION*
24
Setting up and connecting the
coffee machine
Danger of overheating due to
insufficient ventilation.
If the coffee machine is not
sufficiently ventilated, the appliance
can overheat.
Please ensure that there is adequate
ventilation around the coffee
machine.
Do not cover the coffee machine
with dish towels, etc. while it is in
use.
If the coffee machine is installed in a
built-in niche, heat and moisture will
accumulate inside the alcove. This
can result in damage to the coffee
machine and/or cabinetry.
Do not install the appliance in a built-
in niche.
Please observe the following installation
instructions:
- The location of the appliance must be
dry and well ventilated.
- The ambient temperature of the room
in which the appliance is used must
be between +50°F and +100°F
(+16°C and +38°C).
- Do not place the coffee machine near
a window in direct sunlight or right
next to an appliance that gives off
heat. This would subject the machine
to ambient temperatures outside of
its permitted range.
- The coffee machine must be set up
on a level surface. The surface must
be water resistant.
- The service panel must be opened
completely to remove the brew unit.
Place the coffee machine in the
location you want to use it.
Clean the coffee machine thoroughly
before filling it with drinking water
and coffee beans.
Insert the electrical plug of the coffee
machine into the socket (see
“Electrical connection”).
Remove the water container and fill it
with fresh, cold drinking water. Only
fill the container up to the “max.”
mark.
Reinsert the water container.
Tip: The milk pipework can be stored
behind the service panel when not in
use.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
