Using for the first time
19
Setting the water hardness lev‐
el
The water hardness level of the steam
oven is set to "Very hard" at the factory.
For trouble-free operation of the steam
oven, and to ensure that it is descaled
at the appropriate time, it is important
to set the water hardness level for your
area. The harder the water, the more of‐
ten the steam oven must be descaled.
Check which water hardness level
has been set and, if necessary, set
the correct water hardness (see "Set‐
tings - Water hardness").
Setting the correct boiling
point for water
The boiling point for water depends on
the altitude above sea level.
The steam oven is set ex-works for an
installation location of under 1000 m. If
it is located at more than 1000 m above
sea level, the factory default setting will
have to be changed (see "Settings").
Opening the door
Using the thumb of your right hand,
push the door release forwards and
turn the handle upwards.
When it is in a horizontal position, the
door is unlocked and can be opened.
To Next Page
Loading...
Need help?
General
