Plumbing in the appliance
98
– IMPORTANT Australia and New Zea‐
land This appliance must be installed
according to AS/NZS 3500.1. Back
flow prevention is already integrated
in the appliance.
– The water quality must conform to
the requirements for drinking water in
the country in which the appliance is
being installed.
– The water inlet hose must be con‐
nected to the mains drinking water
supply by a tap with a ³/₄" threaded
union. If this is not present, one must
be installed by a suitably qualified
plumber.
– The tap must be easily accessible af‐
ter the appliance has been installed.
– Only genuine original Miele hoses
can be used with this appliance.
Connection to the mains water
supply
Danger of electrical shock!
Plumbing connections cannot be
made while the appliance is connec‐
ted to the mains electricity supply.
Disconnect the appliance from the
mains electricity supply.
Connect the stainless steel inlet hose
to the tap.
Ensure that the hose is fitted correct‐
ly and that it is watertight.
The connection point is subject to
mains water pressure. Turn on the tap
slowly and check for leaks. Correct
the position of the washer and union if
necessary.
To Next Page
Loading...
Need help?
General
