Do not fill the salt reservoir with
water.
^ Add salt only until the reservoir is full
or until water runs out of the opening.
The salt reservoir holds approx. 1 kg
of salt, depending on the brand
used.
Do not add any more than 1 kg of
salt.
As the salt reservoir is filled, displaced
water may overflow.
^
Clean any excess salt from around
the reservoir opening, and then close
the flap.
^
After refilling the salt reservoir, run
the Quick wash programme immedi
-
ately (without any crockery in the
dishwasher, and without selecting the
Turbo extra option) to remove any
traces of salt from the cabinet.
"Insufficient salt" message
^
Fill the salt reservoir with dishwasher
salt for reactivation when the
Insufficient salt message appears.
(If it appears during a programme,
wait until the end of the programme).
^
Confirm with
OK.
The "Insufficient salt" message will go
out.
After the salt reservoir has been filled,
the "Insufficient salt" message may still
appear in the display if the salt
concentration has not yet reached the
correct level.
If this is the case, confirm again with
OK.
The insufficient salt message will not
appear if the dishwasher has been
programmed for a water hardness level
of less than 0.7 mmol/l (4 °d - German
scale).
,
After refilling the salt reservoir,
run the Quick wash programme im
-
mediately (without any crockery in
the dishwasher, and without
selecting the Turbo extra option) to
remove any traces of salt from the
cabinet.
Before using for the first time
21
To Next Page
Loading...
Need help?
General
