Problem solving guide
104
Problem Cause and remedy
Fault 492, 504 A programme has been cancelled because there is not
enough spray pressure. The filters in the wash cabinet may
be blocked.
Danger of injury from glass shards, needles, etc.
retained in the filters.
Check and clean the filters in the wash cabinet (see
“Maintenance/Cleaning the filters in the wash cabinet”).
Fault 550 The waterproof system has been activated. One of the
water supply hoses might have a leak.
Close the stopcocks.
Contact the Miele Customer Service Department.
Fault578 The peak load cut-out has lasted longer than 3hours.
Have your electrical system and your energy
management system tested by a suitably qualified
person.
Process-related faults and messages
Problem Cause and remedy
Wrong code entered The PIN code entered is not the same as the code saved.
Enter the PIN code again.
Report the loss of the PIN code to the Miele Customer
Service Department.
Programme cancelled This is not a fault.
A programme which was running was cancelled by the user.
The wash cabinet interior can be very hot.
When the door is opened, hot steam and chemical
agents can escape. Protective measures for personal
safety must be observed.
Programme continued This is not a fault.
The process of cancelling a programme was not completed.
The programme which was running continued without
interruption.
Peak load cut-out
This is not a fault.
Individual components of the machine are paused while
there is a peak load signal from your energy management
system.
All settings reset This is not a fault.
A user has restored factory default settings.
Confirm the message with OK.
All programme settings reset This is not a fault.
A user has restored the factory setting for the programme.
Confirm the message with OK.
To Next Page
Loading...
Need help?
General
