Settings
68
Volume
A buzzer which is integrated into the control panel can give an
acoustic signal in the following situations:
- When buttons are pressed (keypad tone)
- At the end of the programme
- System messages (information)
Open the systems menu by switching the machine off with the
button and then with the held in switch it back on with the
button.
Open the menu as follows:
Settings
Volume
Buzzer tones
Buzzer tones
Keypad tone
- Buzzer tones
Setting the buzzer volume for programme end and system
messages (information)
- Keypad tone
Setting the buzzer volume for keypad tone.
Select an option using the and arrow buttons.
Confirm your selection with OK.
When Keypad tone has been selected you can adjust the volume
immediately. When Buzzer tones has been selected you must first
select which tone, Warning or Programme end, you would like to
adjust the volume for.
Programme end
LouderQuieter
Keypad tone
Quieter Louder
The volume level is represented by a bar chart. On the lowest setting
the buzzer tone is switched off.
Use the arrow buttons (Louder) and (Quieter) to set the volume.
Press OK to save the setting.
To Next Page
Loading...
Need help?
General
