Problem solving guide
107
Water inlet and drainage
Problem Cause and remedy
Check water inlet One or more stopcocks are closed.
Open the stopcocks.
There was insufficient water in the machine.
Clean the water intake filters.
Open the stopcocks fully.
The supply pressure at the water connection is too low.
Refer to the specifications for supply pressure in the
“Technical data”.
Contact a suitably qualified installer.
Check drainage A programme was cancelled because the water in the
wash cabinet is only being pumped away slowly or not at
all.
- The drain hose is blocked.
Remove any kinks or large loops in the drain hose.
Start the programme again.
- The filters in the wash cabinet are blocked.
Clean the filters in the wash cabinet.
Danger of injury from glass shards, needles, etc.
retained in the filters.
Start the programme again.
- The drain pump or the non-return valve is blocked.
Clean the access to the drain pump and the non-return
valve.
Start the programme again.
- The drainage system cannot take in enough water
because it is blocked.
Contact a suitably qualified plumber.
To Next Page
Loading...
Need help?
General
