Programme settings
111
Setting the
concentration
level
Up to two chemical agents can be dispensed in each wash block. It is
also possible to control the same dispensing system twice.
...
Dosage 1 or Dosage 2
Dispensing system
Dispensing system
DOS 1 ...
DOS ...
The number of dispensing systems can vary according to model and
the number of connected DOS modules.
Select an option using the and arrow buttons and save your
choice with OK.
Then you can set the dispensing concentration in % (percent).
Adjustment is in 0.01% increments. The possible range is shown in
the bottom line.
Use the arrow buttons (higher) and (lower) to set the
dispensing concentration.
Press OK to save the setting.
To Next Page
Loading...
Need help?
General
