Guide to the machine
13
LEDs in buttons
The buttons on the control panel have LEDs (Light Emitting Diodes). They indicate the
status of the machine.
Button LED Status
button ON The machine is switched on.
FLASHES The machine is ready for use.
OFF The machine is switched off.
Programme
selection
buttons,
and
ON The respective programme has been selected. At the
end of the programme the LED will remain lit until a
different programme is selected.
OFF The programme is not selected or the programme
settings are being selected.
button ON A programme has been selected from the
programme list. At the end of the programme the
LED will remain lit until a different programme is
selected.
OFF No programme has been selected from the list or the
programme settings are being changed.
button ON The additional “Drying” function has been activated
for the selected programme (not available for all
programmes, see “Programme chart”).
OFF The additional “Drying” function has been
deactivated.
Start/Stop
button
ON A programme is running.
FLASHES
GREEN
A programme has been selected but not yet started.
FLASHES RED A fault has occurred (see “Problem solving guide”).
OFF A programme has finished.
button ON The door is closed (locked) and there is no
programme running.
FLASHES A programme has finished and the door is closed
(locked).
OFF A programme is running or the door is open
(unlocked).