Installation
*INSTALLATION*
154
Building under a continuous worktop
Removing the
lid
To build the machine under a continuous worktop the lid must be
removed as follows:
Unscrew both securing screws from the lid at the back of the
machine.
Open the door.
Unscrew the left and right fixing screws.
Lift the lid off.
Steam condenser
To avoid steam damage to the worktop the protective foil supplied
(25 x 58cm, self-adhesive) must be applied underneath the
worktop in the area of the steam condenser.
Preventing heat
build-up
During the drying phase, the hot exhaust air from the wash cabinet is
released into the surrounding environment through the steam
condenser at the rear of the machine. Sufficient ventilation must be
ensured to prevent heat build-up and excessive condensation.
Leave a minimum distance of 10mm for air exchange between the
machine and the worktop.
If necessary ventilation grilles should be fitted in the side units.
To Next Page
Loading...
Need help?
General
