Installation
*INSTALLATION*
153
Installation and levelling
Please refer to the installation diagram provided.
In order to reduce the risk of water damage, the area around the
machine should be limited to furniture and fittings that are designed
for use in commercial environments.
The machine must be stable and level.
Any unevenness in the floor level and height of the machine can be
compensated for by adjusting the four feet. The feet can be screwed
out to a maximum of 60mm.
Do not lift the machine by protruding parts such as the control
panel.
They could be damaged or torn off.
Some metal parts pose a risk of injury/being cut.
Wear cut-resistant protective gloves when transporting and setting
up the machine.
For transport by means of a hand truck, the machine must be in
its original packaging or placed on a stable, continuous support.
Otherwise, components in the base of the machine can be
damaged.
The machine is suitable for the following types of installation:
- Freestanding.
- Slot-in:
The machine can be installed beside other appliances or furniture
or in a suitable niche. The niche must be at least 600mm wide and
600mm deep.
- Built-under:
The machine can be built under a continuous worktop or the
draining board of a sink. The space provided must be at least
600mm wide, 600mm deep and 820mm high.
To Next Page
Loading...
Need help?
General
