Miele PG 8593 User Manual

Operation
58
Programme sequence indicator
After the programme has started, the programme sequence can be
followed on the three-line display.
Universal
Main wash 1
Time left
Min25
Top line
- Programme name.
Middle line
The following parameters can be checked using the  and  arrow
buttons:
- Current programme block, e.g. Main wash 1,
- Actual or required temperature
(depending on the display set, see “Further settings/Display:
Temperature”),
- A
0
value,
- Conductivity
(only with conductivity meter).
- Cycle number,
Bottom line
- Time left (in hours; under an hour, in minutes).
At the end of the programme
A programme is usually finished when the following parameters and
messages are shown in the display:
Top line
- Programme name.
Middle line
Continuously alternating between:
- Parameter met/not met,
- A
0
value,
- Conductivity in final wash block
(only with conductivity meter).
- Cycle number,
Bottom line
- Programme finished.
In addition, the LED in the Start/Stop button goes out and the LED in
the  button begins to flash. In the factory default state, an acoustic
tone also sounds for approx. 10 seconds (see “Settings/Volume”).

Miele PG 8593 Specifications

General

Brand	Miele
Model	PG 8593
Category	Laboratory Equipment
Language	English