Maintenance
127
Cleaning the machine
Never clean the machine or near vicinity with a water hose or a
pressure washer.
Do not use cleaning agents containing ammonia or thinners on
stainless steel surfaces!
These agents can damage the surface material.
Cleaning the
control panel
Do not use any abrasive materials or general-purpose cleaners
to clean the control panel.
These can cause considerable damage to the glass and plastic
surfaces and to the onset control buttons.
Clean the control panel with a damp cloth and a little washing-up
liquid or with a non-abrasive stainless steel cleaner.
Proprietary glass or plastic cleaning agents can also be used to
clean the display.
For surface disinfection use a listed agent recommended by the
manufacturer.
Cleaning the door
and the door seal
Wipe the door seals regularly with a damp cloth to remove any
soiling.
Seals which are no longer tight or which have suffered damage
must be replaced with new ones by the Miele Customer Service
Department.
Remove any stains from the door sides and hinges.
Regularly clean the groove in the plinth panel under the door with a
damp cloth.
Cleaning the
wash chamber
The wash chamber is generally self-cleaning. However, should a
build-up of deposits occur in the chamber, please contact the Miele
Customer Service Department for advice.
Cleaning the door
front
To clean the stainless steel front, use a damp cloth with a solution
of washing-up liquid and hot water, or with a non-abrasive cleaning
agent for use on stainless steel.
Preventing
re-soiling
To help prevent re-soiling of stainless steel surfaces (fingerprints,
etc.), a suitable stainless steel conditioner can be used after
cleaning.
To Next Page
Loading...
Need help?
General
