Further settings
89
Renaming a
dispensing
system
If required the names of the dispensing systems “DOS1”, “DOS2” etc.
can be extended to include additional information e.g. “DOS1 cleaning
agent”. The name “DOS” and the accompanying number cannot be
changed.
Use this option to document all changes to factory settings in case
of a subsequent Service call requirement.
If the option
- Change name
has been selected, the display changes to the following view:
The current name is shown on the second line of the display. This can
be changed using the options shown in the bottom line. The top line
shows which option has been selected from the bottom line.
Names may consist of up to 15 characters including spaces. The
following options are available:
- Letters from A to Z,
each new word will start with a capital letter.
- Numbers from 0 to 9.
- Space .
- Use the symbol to delete the last position.
- The name is saved when the OK symbol in the display is selected.
The display will then revert to the initial menu.
- The symbol in the display or the button end the process
without saving the name change. The display reverts to the initial
menu.
Use the arrow buttons (right) and (left) to move the cursor to
the option you require.
Confirm each entry with OK.
To Next Page
Loading...
Need help?
General
