Supervisor level
68
Programme selection
Controls
Useful tip: Start by configuring all necessary settings and changes to
the washing machine before adjusting any of the options below.
If “Launderette, basic” or “Launderette Logo” is selected, the
Supervisor level can no longer be opened from the display after the
Supervisor level is closed. Please follow the instructions below for
special access to the Supervisor level if you wish to change any other
settings.
Standard (factory default setting).
All functions and programmes can be displayed.
Launderette, basic
Up to 12 programmes are available. Go to Favourite programmes to
select which programmes are to be listed.
Launderette logo
Up to 12 programmes are available. Go to Favourite programmes to
select which programmes are to be listed.
External programme selection
Programmes are selected using a communication module, e.g. an
external terminal.
Programme
packages
The selection of programmes can be expanded by activating single
programmes from the target group programme packages.
The programmes selected from the programme packages (marked in
orange) are displayed during programme selection.
Favourite
programmes
After switching on, you can also select a programme via:
Favourites.
24 programmes can be stored as favourite programmes based on
your own priorities and requirements.
These favourite programmes will also be made available in the control
options
- Launderette logo
- Launderette, basic control options.
You can specify the control options under Controls.
Useful tip: You can assign a separate coloured frame to each
programme. In this case, the Prog. colour allocation setting must be
set to On.
Changing favourite programmes
Select the programme you wish to change or replace.
Confirm the programme or the setting to be changed.
To Next Page
Loading...
Need help?
General
