Warning and Safety instructions
8
Correct application
The washing machine is only suitable for washing fabrics with a
care label stating that they are suitable for machine washing. Any
other applications may be dangerous. The manufacturer cannot be
held liable for damage resulting from incorrect or improper use or
operation of the machine.
This washing machine must be used as described in the operating
instructions and must be checked on a regular basis to make sure it
is functioning correctly. Maintenance must be carried out when
necessary.
The washing machine is not suitable for outdoor use.
Do not install the washing machine in a room where there is a risk
of frost. Frozen hoses can tear or burst. The reliability of the electronic
control unit may be impaired at temperatures below freezing point.
The washing machine is designed for commercial use only.
If the machine is used in a commercial environment, it may only be
operated by instructed/trained personnel. If the machine is to be
operated in an area accessible to the public, the supervisor must
ensure that it can be operated safely without risk of danger to others.
The machine must not be installed and operated in mobile
locations (e.g. on a ship).
This washing machine is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning its use by a person responsible
for their safety.
Young children must not be allowed to use this appliance.
Older children may only use the appliance when its operation has
been clearly explained to them and they are able to use it safely. They
must be able to understand and recognise the possible dangers of
misuse.
Cleaning or maintenance on the washing machine may only be
carried out by older children under the supervision of an adult.
Always supervise any children in the vicinity of the washing
machine. Never allow children to play with the washing machine.
Disinfection programmes must not be interrupted, as this can have
a limiting effect on the disinfection result. It is the operator’s
responsibility to ensure that the standard of disinfection in thermal as
well as chemo-thermal procedures is maintained by carrying out
suitable validation tests.
To Next Page
Loading...
Need help?
General
