Miele PWM 906 User Manual

Problem solving guide
56
Program cancellation and error message
Problem Possible cause and solution
 Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum drain height is 1m.
 Water intake fault.
Open the tap.
The water intake is blocked or restricted.
 Check whether the shutoff valve is turned on
properly.
 Check whether the intake hose is kinked.
The water pressure is too low.
 Switch on the Low water pressuresetting (see “Low
water pressure” under “Supervisor level”).
The filters in the water intake are blocked.
 Clean the filters (see “Cleaning the filters” under
“Cleaning and care”).
 Waterproof system
activated
The water protection system has reacted.
 Close the shutoff valve.
 Contact Miele Service.
 Disinfection
temperature not
reached.
The required temperature was not reached during the
disinfection program.
 The washing machine has not carried out the
disinfection cycle correctly.
 Start the program again.
 Fault F. If restart
fails, call Service.
There is a fault.
 Disconnect the washing machine from the
electrical supply.
 Wait at least 2minutes before reconnecting the
washing machine to the electrical supply.
 Then switch the washing machine on again.
 Start the program again.
If the error message appears again, contact Miele
Service.

Miele PWM 906 Specifications

General

Brand	Miele
Model	PWM 906
Category	Washer
Language	English