Supervisor level
80
Operation/display
Language
The display can be set to appear in
one of several different languages. To
select the permanent supervisor
language you want, go to the
Languages sub-menu.
When a program is running, you can
change the user language using the
sensor control.
Language menu
The display can be set to one of
several different user languages. This
setting allows you to determine how
languages can be selected.
International
6 languages are available. The
sensor control is not active. Note
the setting Set languages.
Language setting
The sensor control can be used
to select a language. All languages are
available (factory default).
You can change the order of the first 4
languages. These slots are allocated to
the most commonly used languages.
Standard language
The user language cannot be changed.
The user language is the same as the
supervisor language. The sensor
control is not active.
Set languages
The languages for the setting Language
entry International can be changed.
6 languages can be selected. All
languages are available.
If you wish to add a new language to
the language menu:
First select the language you want to
replace.
All available languages are displayed.
Select and confirm the language to
replace the previous language.
The new language appears instead of
the old one.
Display brightness
The brightness of the display can be
altered. The setting depends on the
various lighting conditions in the place
of installation.
It can be set to one of 10 different
levels.
To Next Page
Loading...
Need help?
General
