Miele T 4859 Ci User Manual

Emptying the condensed water
container
The condensed water will be collected
in the condensed water container
unless the appliance has been set up
to drain via the drain hose (see
installation).
Empty the condensed water
container after every drying
programme.
The drying programme will be
interrupted if the maximum level of the
condensed water container is reached.
A message will appear in the display.
^
Holding the container firmly in both
hands, as shown, pull it out slightly
towards the right-hand side.
^
Hold the container in a horizontal
position when carrying it.
^ Open the shutter and empty out the
water.
^ To replace the container, hold it at a
slight angle (as when removing it)
and push it in gently until you feel it
click into position.
^ To remove the message from the
display, switch the dryer off and then
on again.
Condensed water should not be
consumed. It could lead to health
problems for people and animals.
Condensed water can be put to
household use (e.g. used in a steam
iron or humidifier). To ensure that any
residual particles of fluff in the
condensed water are removed before
use, pass it through a fine sieve or
paper filter first.
Cleaning and care
39

Miele T 4859 Ci Specifications

General

Control type	Buttons
Display type	LCD
Loading type	Front-load
Drying system	Condensation
Product color	Stainless steel
Built-in display	Yes
Appliance placement	Freestanding
Drying class	-
Drum capacity	6 kg
Maximum spin speed	1400 RPM
Delay start (max)	24 h
Current	13 A
Connected load	2850 W
AC input voltage	220-230 V
AC input frequency	50 Hz
Energy consumption	3.35 kWh
Annual energy consumption	265 kWh

Weight and Dimensions

Depth	575 mm
Width	595 mm
Height	820 mm
Weight	52000 g
Depth with door open	1150 mm