Problem solving guide
65
With the help of the following notes minor faults in the performance of the appli‐
ance, some
of which may result from incorrect operation, can be put right without
contacting the Service Department.
Repair w
ork to electrical appliances must only be carried out by a suitably
qualified person in strict accordance with current local and national safety regu‐
lations. Repairs and other work by unqualified persons could be dangerous.
The manufacturer cannot be held liable for unauthorised work.
Messages in the display
Problem Cause and remedy
Code
000 lig
hts up after
switching on
Access via a code has been activated.
See "Settings menu, Code".
Adjust the load
lights up after a pro‐
gramme has been can‐
celled
In some programmes, if the drum has been underloa‐
ded
or is empty, the programme will be cancelled.
This can also happen if the items are already dry.
Op
en and close the door to resume drying.
Dr
y individual items using the Warm air timed dry‐
ing programme.
It may be that the laundry is unevenly distributed or
has r
olled up.
Disentan
gle the laundry and remove a few items, if
necessary.
S
tart the programme again.
Technical fault F
If restart is unsuccessful call
Service.
li
ghts up after a pro‐
gramme has been can‐
celled
No obvious cause.
Switch the dr
yer off and then on again.
S
tart a programme.
If the programme is cancelled again and an error
message
appears, there is a fault. Contact the Miele
Service Department.
To Next Page
Loading...
Need help?
General
