Pellerin Milnor Corporation 9
load size the dry weight (in pounds or kilograms) of a load of goods. Specific goods types can
require specific load sizes and these can vary significantly.
capacity the load size rating for a washer-extractor, as stated in the specifications shown on the
product brochure. This rating does not reflect factors such as goods type and soil content.
You will get the best performance from your machine if you use the correct load sizes. Under-
loading can make it difficult for the machine to distribute (balance) the goods before extraction.
This can cause excessive recycles (when the machine repeatedly tries to distribute the goods). Oc-
casional small loads may be necessary, but keep these to a minimum. Over-loading can put in-
creased stress on machine components and reduce wash quality.
CAUTION: Incorrect load sizes — can cause premature machine wear, excessive re-
cycles (which extends formula time), and poor wash quality.
� Use a chart of goods types and load sizes from your supervisor or laun-
dry management.
� Minimize the number of small loads.
� Use a scale to determine when a load is the correct size.
� On a divided-cylinder machine, put approximately the same weight of goods in each
pocket.
When your machine was purchased, your Milnor
®
dealer worked with your laundry personnel to
determine the optimum machine for your needs. This took into account factors such as the types
of goods to be washed and the expected soil content of the goods, which can cause the correct
load size to vary greatly among goods types. For example, the more bulky the goods, the smaller
the permissible load size. The correct load sizes will be what was previously determined when
the machine was purchased. If you do not already have a chart of the goods types to be processed
and their correct load sizes, request one from your supervisor or laundry management.
3.1.2.1 Weighing Goods
BNWUUO02.C04 0000255516 A.10 D.4 C.12 9/11/20 8:48 AM Released
Build loads of the correct size for the best performance from your machine. The most accurate
method to build loads of the correct size is to weigh each load as you assemble it.
You can weigh the goods using a separate laundry scale, weighing-type load conveyor, etc. If
your machine is connected to a Mildata
®
network and configured to pass weight data, be sure to
record the weight of each load so that you can enter it into the Remote Formula window (Figure
7: Remote Formula Window, page 11 ) before you run a formula.
BNCLJO12 / 2020403
BNCLJO12 0000213992 B.20 9/29/20 9:47 AM Released
3.2 Apply control power.
BNCLJO12.T03 0000214800 A.10 B.20 B.9 9/11/20 9:00 AM Released
Set the master power switch ( ) to . Control power must be on to use the electrome-
chanical controls and the touchscreen controller.
Normal Operation
12
To Next Page
Loading...
Need help?
General
