Minelab gpz 7000 User Manual

Wireless Audio Module
30
Wireless Audio Module
The Wireless Audio Module (WM 12) facilitates the use of
wireless audio, using advanced WiStream technology to
achieve clear sound with no perceivable time delay.
It contains an internal loudspeaker and ¼" headphone
socket for use with your choice of headphones. It can be
used with the attached belt clip or simply dropped into
your pocket.
The WM 12 operates on a single selectable RF channel in
a global license-free location of the radio spectrum. The
WM 12 has 14 channels, which allows multiple detectors
to be used within the same vicinity without degraded
performance.
WARNING
WM 12 is NOT waterproof.
Power LED
Power Button
Pairing LED
Pairing Button
Belt Clip
Reset Button*
* If you experience
difficulties with
your WM 12,
insert a paperclip
here to reset.
Connect the WM12
Ensure that your WM 12 battery is fully charged before
you go detecting. For instructions on how to charge your
WM 12, see “Recharge the WM 12” on page 8.
It is only necessary to perform the connection procedure
once. After initial connection the detector and WM 12 will
connect automatically when the WM 12 is turned on.
To connect the WM 12 to your detector, navigate to
‘Connect WM 12’ in the Settings menu and select it
to launch a wizard that will guide you through the
connection process.
During the wizard, a channel will be automatically chosen
and displayed. To adjust the channel, press the left or right
arrow keys to decrease or increase the channel, which
is displayed on the screen. Press the Select button to
confirm the channel.
Connect WM 12 wizard showing channel selection function
Once wireless is enabled and the WM 12 is connected, all
audio is expected to be generated by the WM 12 even
if it is turned off. Disable wireless to return audio to the
detector.
Use the Wireless Enable function on the Settings page on
your detector to enable or disable the Wireless function
(page 21).
Notes
The WM 12 Pairing LED may blink red
occasionally when the WM 12 appears
to be working correctly. This indicates a
deterioration in radio communications and
is for information only.
Reset the WM12
If you experience any difficulties with your WM 12, reset
the device by using a paper clip to press the reset button.

Minelab gpz 7000 Specifications

General

Brand	Minelab
Model	gpz 7000
Category	Security Sensors
Language	English