5 - 1 5 - 1
MELSEC-A
5 PROGRAMMING
5 PROGRAMMING
This chapter explains the programming of the AJ65SBT-CLB.
When applying any of the program examples introduced in this chapter to the actual
system, verify the applicability and confirm that no problems will occur in the system
control.
Refer to the user's manual of the master module for details of that module, to Section
3.7 for the remote registers, and to the AnSHCPU/AnACPU/AnUCPU/QCPU-A (A
Mode) Programming Manual (Dedicated Instructions) for details of the dedicated
instructions.
5.1 Conditions of Program Examples
The program examples in this chapter are based on the following conditions.
(1) System configuration
24VDC
CL1PAD1
PLC CPU
Master station (X0 to X1F/Y0 to Y1F)
I/O (64 input points) (X20 to X5F)
I/O (64 output points) (Y60 to Y9F)
AJ65SBT-CLB (Station No. 1)
Number of occupied stations setting (CC-Link side) : 2 stations
Transmission speed setting (CC-Link side) : 156kbps
Point mode setting (CC-Link/LT side) : 4-point mode
Transmission speed setting (CC-Link/LT side) : 156kbps
Terminating resistor
Power supply adaptor
General power supply
Remote I/O station
(Station No. 1)
Remote I/O station
(Station No. 3)
CL2X8-D1C3V
Input module
(X400 to X407)
CL2Y8-TP1C2V
Output module
(Y408 to Y40F)
Terminating resisto
5
To Next Page
Loading...
Need help?
General
