ITEM SETTING FUNCTION
ASPECT NORMAL (FULL) Input video signal is displayed at the max height (1200 pixels)
or max width (1920 pixels) of the panel while its aspect ratio is
maintained.
NORMAL (16:9) Select this setting when using a 16:9 screen.
NORMAL (4:3) Select this setting when using a 4:3 screen.
16:9 Regardless of the type of input signal, image is displayed at 16:9
aspect ratio (1920 x 1080 pixels). Select to expand squeezed (or
horizontally compressed) images such as DVD images to 16:9.
Press the ENTER button to select whether or not to display signals
at 16:9 depending on their type. (See page 25.)
REAL Input video signal is displayed at its original pixel size.
FULL Select to project images in full size (1920 x 1200 pixels) irrespective
of type of input signal.
PROJECTOR ID ALL Select this option to control the projector regardless of the ID
number. (See page 60.)
01 to 63 Use to set the ID number (two-digit number). (See page 60.)
GROUP ID A to Z Use to set the ID number for controlling multiple projectors by
groups for monitoring and control via the SERIAL terminal. (See
page 60.)
PASSWORD FUNCTION DISPLAY INPUT
/
MENU ACCESS
/
SPLASH ID SCREEN
Use to enable or cancel the password lock. See page 56 for details.
MENU POSITION 1 (upper left) / 2 (lower right) /
3 (center)
Use to change the position of the menu.
CINEMA MODE AUTO The film mode will be automatically activated when a film source
signal is input.
Select AUTO for normal use.
When flicker occurs on the screen, frame dropping or other incorrect
display occurs, or jaggies on slanting lines are remarkable, select
either FILM or VIDEO, which improves the symptom better.
FILM Fixed to the film mode.
VIDEO The film mode will not be activated.
LANGUAGE
/ English / Español /
Deutsch / Français / Italiano /
/ / /
PORTUGUÊS / SVENSKA /
POLSKI / Nederlands/
Norsk(Bokmål) / Türkçe /
/ Bahasa Indonesia /
Bahasa Melayu /
Use to select the language used in the menus.
ADVANCED MENU ENTER The ADVANCED MENU is displayed for the following settings.
VIDEO SIGNAL AUTO / NTSC / PAL / SECAM
/ 4.43NTSC / PAL-M / PAL-N /
PAL-60
When AUTO is selected, the appropriate video format is
automatically selected depending on the input signal. If the image
isn’t displayed correctly, select the desired video format manually.
SETUP AUTO Select to change the SETUP mode automatically.
OFF Select to make black lighter.
3.75%/7.5% Select to make black thicker.
• When7.5%ischosen,thebrightnessisdecreasedbytheset-
up cancel function for the U.S. Choose OFF when the image is
dark.
Menu operation (continued)
To Next Page
Loading...
Need help?
General
