ITEM SETTING FUNCTION
PROJECTOR NAME *****... Displays PROJECTOR NAME. Displays PROJECTOR NAME in blank
when PROJECTOR NAME is not set. (See page 49.)
SET
Set the name to identify the projector. Enter up to 15 characters
(alphabets or numeric characters). (See page 49.)
NETWORK PASSWORD ENTER Set the password for Web control or PJLink certification. (See page
49.)
IP CONFIG ENTER Select this setting for IP Configuration. (See page 50.)
DHCP
ON
/ OFF
Use this setting when you obtain IP CONFIG automatically by DHCP
server.
IP ADDRESS ***.***.***.*** Displays IP ADDRESS. However, IP ADDRESS is not set as factory
default, and cannot be displayed.
SET
Set IP ADDRESS. When DHCP is set to ON, you cannot change
this setting.
SUBNET MASK ***.***.***.*** Displays SUBNET MASK. However, SUBNET MASK is not set as
factory default, and cannot be displayed.
SET
Set SUBNET MASK. When DHCP is set to ON, you cannot change
this setting.
DEFAULT GATEWAY ***.***.***.*** Displays DEFAULT GATEWAY. However, DEFAULT GATEWAY is not
set as factory default, and cannot be displayed.
SET
Set DEFAULT GATEWAY. When DHCP is set to ON, you cannot
change this setting.
MAC ADDRESS xx-xx-xx-xx-xx-xx Displays MAC ADDRESS.
NETWORK CERTIFICATION
ON
/ OFF
Select whether to enable the network certification or not. Select ON
for normal use. (See page 51.)
CONTROL SYSTEM STANDARD Select this setting when using ProjectorView Global+ or ProjectorView.
(See pages 51 and 58.)
AMX Select when using a controller made by AMX. (See pages 51 and 58.)
CRESTRON Select this setting when using the controller or software of Crestron
Electronics, Inc. (See pages 51 and 58.)
NETWORK RESET OK Resets the Network Setting. (See page 52.)
Menu operation (continued)