Room lamps
For pleasant driving 7-13
7
E00712003224
When using USB port for charging (Type-
A), be sure that the power consumption of
the connected USB device does not exceed
12 W {the peak outlet current or voltage of
the USB port for charging (Type-A) is DC 5
V-2 .4 A}.
When using USB port for charging (Type-
C), be sure that the power consumption of
the connected USB device does not exceed
15 W {the peak outlet current or voltage of
the USB port for charging (Type-C) is DC 5
V-3 A}.
The connected devices or the USB port for
charging may be damaged.
Do not use the reversible USB connector
cable that the USB connector board is
located in the centre.
The USB port for charging might be dam-
aged.
Long use of the electric appliance when the
READY indicator is not illuminated may run
down the auxiliary battery.
The USB ports for charging can be used only
as a power source. These are not connected
to the audio devices of the vehicles.
Do not charge many mobile devices together
by using a multi-plug adapter of the USB
port for charging.
If water or spill beverages has splashed on
the USB ports for charging, stop using it and
have the vehicle checked by an authorised
MITSUBISHI MOTORS dealer.
Room lamps
1- Room lamp (front)
2- Room lamp (rear)
If you leave the lamps on when the READY
indicator is not illuminated, you will run
down the auxiliary battery. Before you leave
the vehicle, make sure that all the lamps are
off.
Position
of lamp
switch
On/off control
1-
()
The lamps illuminates regard-
less of whether a door or the
tailgate is open or closed.
To Next Page
Loading...
Need help?
General
