Mitsubishi XPANDER HEV 2023 User Manual

Seat belt inspection
Seat and seat belts 4-23
4
4. Remove all slack of a lap belt by pulling
the webbing through the belt’s adjustment
feature.
3-point type seat belt requires no length
adjustment, remove all slack by using the
locking clip.
5. Before putting the child in the restraint,
push and pull the restraint in all directions
to be sure it is secure. Do this before each
use.
Remove the plate from the buckle, then
remove the seat belt from the child restraint
system.
E00406302017
Check the belts for cuts, worn or frayed web-
bing and for cracked or deformed metallic
parts. Replace the belt assembly if defective.
E00407203690
The information written in this supplemental
restraint system (SRS) section contains
WARNING
 For some types of child restraint, the lock-
ing clip (A) should be used to help avoid
personal injury during a collision or sud-
den manoeuvre.
It must be fitted and used in accordance
with the child restraint manufacturer’s
instructions.
The locking clip must be removed when
the child restraint is removed.
To remove
Seat belt inspection
WARNING
 We recommend you to have all seat belt
assemblies including retractors and
attaching hardware inspected after any
collision. We recommend that seat belt
assemblies in use during a collision be
replaced unless the collision was minor
and the belts show no damage and con-
tinue to operate properly.
 Do not attempt to repair or replace any
part of the seat belt assemblies; we recom-
mend you to have this work done by an
authorised MITSUBISHI MOTORS
dealer. Incorrect repair or replacement
could reduce the effectiveness of the belts
and could result in serious injury in the
event of a collision.
 Once the pre-tensioner has activated, it
cannot be re-used.
It must be replaced together with the
retractor.
 Do not insert any foreign objects (pieces of
plastic, paper clips, buttons, etc.) in the
buckle or retractor mechanism. In addi-
tion, do not modify, remove, or install
the seat belt. Otherwise, the seat belt may
not be able to provide adequate protection
in a collision or other situation.
 A dirty belt should be cleaned with neu-
tral detergent in warm water. After rins-
ing in water, let it dry in the shade. Do not
attempt to bleach or re-dye the belts
because this affects their characteristics.
Supplemental restraint sys-
tem (SRS) - airbag
WARNING

Mitsubishi XPANDER HEV 2023 Specifications

General

Brand	Mitsubishi
Model	XPANDER HEV 2023
Category	Automobile
Language	English