Installation of accessories
2-12 General information
2
3. Open the fuel tank filler tube by slowly
turning the cap anticlockwise.
4. Insert the gun in the tank port as far as it
goes.
5. When the gun stops automatically, do not
fill with fuel any more.
6. To close, turn the fuel tank filler tube cap
slowly clockwise until you hear clicking
sounds, then gently push the fuel tank
filler door closed.
E00200303212
Before fitting any accessories, please consult
an authorised MITSUBISHI MOTORS
dealer.
The installation of accessories, optional
parts, etc., should only be carried out
within the limits prescribed by law in your
country, and in accordance with the guide-
lines and warnings contained within the
documents accompanying this vehicle.
1- Remove
2- Close
Since the fuel system may be under pressure,
remove the fuel tank filler tube cap slowly.
This relieves any pressure or vacuum that
might have built up in the fuel tank. If you
hear a hissing sound, wait until it stops
before removing the cap. Otherwise, fuel
may spray out, injuring you or others.
While filling with fuel, store the cap in the
cap holder located on the inside of the fuel
tank filler door.
Do not tilt the gun.
Installation of accessories
Your vehicle is equipped with a diagnosis
connector for checking and servicing the
electronic control system.
Do not connect a device other than a diagno-
sis tool for inspections and service to this
connector. Otherwise, the auxiliary battery
could be discharged, the electronic devices
of the vehicle could malfunction, or other
unexpected problems could result.
In addition, malfunctions caused by connect-
ing a device other than a diagnosis tool may
not be covered under warranty.
To Next Page
Loading...
Need help?
General
