20
REAR PANEL (Continued)
EXT INPUT
Moog One provides an External Audio Input
featuring a Neutrik connector, capable of
accepting either a balanced XLR cable, a balanced
1/4” TRS cable, or an unbalanced 1/4” TS cable.
The TRIM knob can adjust the input gain from -9
dB to +65 dB. There is also a Line Level (LINE)
input equipped with a 1/4” balanced TRS jack
that can accept a balanced 1/4” TRS cable, or an
unbalanced 1/4” TS cable. These external inputs
show up in the Moog One Mixer MORE screen as an additional sound source with a dedicated channel,
although dedicated controls do not exist on the hardware Front Panel. From the Output module’s
MORE page, the LINE Input can be routed to the Insert 3 buss, and the XLR/1/4” combo jack can be
routed to Insert 4.
CV (CONTROL VOLTAGE) I/O
A control voltage is an analog control signal that allows the parameters and functions on one instrument
to interact with the parameters and functions of another instrument in the analog domain. In the days
before MIDI and USB, control voltage was the primary method for interconnection between synthesizers,
and it is still the primary method of interfacing with modular and Eurorack synthesizers today.
Moog One is equipped with two dedicated CV IN jacks (1, 2) and four CV OUT jacks (1, 2, 3, 4).
Additionally, both expression pedal inputs (EXP 1, EXP 2) and the SUSTAIN pedal input may also be
congured for use as control voltage inputs for further analog control.
MIDI (5-PIN DIN)
Moog One offers 5-pin DIN MIDI IN, MIDI
THRU, and MIDI OUT jacks to connect directly
to other MIDI devices, such as sequencers,
drum machines, interfaces, etc. Each Synth in a
Preset can operate on a separate MIDI Channel
for multitimbral control via external MIDI
devices. In addition to note data, the MIDI ports
can be congured to respond to MIDI Clock,
controllers, expression, SysEx, and more.
To Next Page
Loading...
Need help?
General
