47
LOW FREQUENCY OSCILLATORS (Continued)
DEST (DESTINATION)
The DEST (Destination) button provides a quick and easy way to
establish a modulation route using the LFO as the source. Once the
DEST button is pressed, the Modulation Quick Assign screen will
open in the Center Console Display.
The next Front Panel parameter that is
touched or tweaked will become the
modulation destination. In this example,
the Oscillator 2 FREQUENCY knob has
been selected, and turning the knob will
set the modulation amount as shown in
the second screen.
At this point, pressing the DONE Soft
Button at the top of the screen will
complete the modulation routing, or the
CANCEL Soft Button can be used to exit
this modulation screen without making the
modulation route complete. The functions
of the additional Soft Knobs and Soft
Buttons are discussed elsewhere, in the
MODULATION section.
LFO MORE PAGE
Pressing the triangular MORE button in the upper right corner of any
LFO module will reveal its second level of parameters that can be
accessed and modied using the interactive portion of the Center
Console. These additional parameters are displayed in the bottom
portion of the screen. The left pane shows the LFO wave shape as
determined by the LFO WAVE button on the Front Panel and the
VARIATION parameter described below. The right pane shows the
current values of the Front Panel parameters for this module. Tweaking
these Front Panel controls will update their values here.
NOTE: Pressing the (now) illuminated MORE button will exit the MORE
page and recall the HOME screen.
To Next Page
Loading...
Need help?
General
