To Next Page

To Previous Page

OUTPUT (Continued)

The onscreen MORE page parameters are

edited using the four Soft Knobs below

the screen.

CHANGING THE VALUE

Rotate the Soft Knob below the parameter

name to change its value. In some cases,

the Soft Knob simply turns a function on

or off. In other cases, the Soft Knob may

choose from a list of values or settings,

and in other cases, the Soft Knob is

dialing in a value – either absolute or a

percentage.

SELECTING A ROW

The scroll bar at the right edge indicates the current row. Rotate the Master Encoder to the right to

highlight the next row of parameters. Rotating the Master Encoder to the left will select a previous row.

Again, rotate the Soft Knob below the parameter to change its value.

MAIN - SYNTH 1 (OFF, ON)

Setting this parameter to On will route Synth 1 to the MAIN L and MAIN R Outputs.

MAIN - SYNTH 2 (OFF, ON)

Setting this parameter to On will route Synth 2 to the MAIN L and MAIN R Outputs.

MAIN - SYNTH 3 (OFF, ON)

Setting this parameter to On will route Synth 3 to the MAIN L and MAIN R Outputs.

SUB - SYNTH 1 (OFF, ON)

Setting this parameter to On will route Synth 1 to the SUB L and SUB R Outputs on the Rear Panel.

SUB - SYNTH 2 (OFF, ON)

Setting this parameter to On will route Synth 2 to the SUB L and SUB R Outputs on the Rear Panel.

SUB - SYNTH 3 (OFF, ON)

Setting this parameter to On will route Synth 3 to the SUB L and SUB R Outputs on the Rear Panel.

SUB VOLUME (-96 dB to 0 dB to +22 dB)

This parameter allows the output volume of the SUB L and SUB R Outputs to be set independently of

the MAIN L and MAIN R Outputs.

INSERT 1 - SYNTH 1 (OFF, ON)

Setting this parameter to On will route Synth 1 to the INSERT 1 buss.

INSERT 1 - SYNTH 2 (OFF, ON)

Setting this parameter to On will route Synth 2 to the INSERT 1 buss.

INSERT 1 - SYNTH 3 (OFF, ON)

Setting this parameter to On will route Synth 3 to the INSERT 1 buss.

Moog One User Manual

Questions and Answers: