Motorola WR850G User Manual

SECTION 2 INSTALLATION
2-18 SECTION 2, INSTALLATION
DHCP Configuration
The default setting for the router, DHCP is most commonly used for
cable modem connections. There is no configuration necessary for
this setting because the ISP automatically supplies the information.
Your ISP informs you if this is the connection to use.
1 Verify that Cable Modem (DHCP) is selected.
2 Click Apply to save the setting.
PPPoE
PPPoE (Point-to-Point Protocol over Ethernet) setting is most
commonly used for DSL modem connections. Your ISP informs you if
this is the connection to use.
1 From Connection Mode, select DSL Modem (PPPoE).
2 In the PPP User Name field, enter the PPP User Name supplied
by your ISP.
3 In the PPP Password field, enter the PPP Password supplied by
your ISP.
4 Optionally, you might have to enter the PPP Service Name into
this field. Enter the information supplied by your ISP.
5 Click Apply to save the setting, or, if you want to start over, click
Clear.
Static IP
If you are required to use a permanent IP address for connecting to
the Internet, then select Static Assigned. Your ISP informs you if
this is the connection to use.
1 From Connection Mode, select Static Assigned.
2 In the IP address field, enter the IP address supplied by your
ISP.
3 In the Subnet Mask field, enter the Subnet Mask supplied by
your ISP.
4 In the Default Gateway field, enter the values supplied by your
ISP.
5 In the Primary DNS field, enter the values supplied by your ISP. If
necessary, enter secondary or tertiary DNS values into the
Secondary or Tertiary DNS fields.
6 Click Apply to save the setting, or, if you wish to start over, click
Clear.

Motorola WR850G Specifications

General

Brand	Motorola
Model	WR850G
Category	Wireless Router
Language	English