MSI 2000 User Manual

32
Auto Trim
Press Option
to select
Press Option
No
Yes
Use Aileron stick to
toggle between yes
and no. Press
Option to accept.
Moving Aileron stick to the
right advances in the direct
of the arrows. Moving
Aileron stick to the left
reverses the direction.
Press Option from any
selection to enter the
selected function.
Options
Auto Trim
The Auto Trim function allows the aircraft's trim to be adjusted without touching the trims! This is done by holding
the flight controls in a position to make the aircraft fly straight. This function will then adjust the trims in small steps
made a regular intervals. The steps and intervals can be defined in this menu. Two Auto Trim modes are supported, the
Inc mode described above and a single shot mode. In Single Shot mode the entire trim adjustment is made when the
Auto Trim button is pressed.
Options
Auto Trim
Auto Trim
AT ticks
Auto Trim
AT step
Auto Trim
to TZ
Auto Trim
EXIT
Auto Trim
AT ticks 012
Auto Trim
AT step 001
Auto Trim
to TZ Yes(No)
Auto Trim
EXIT Yes(No)
Use elevator stick to
increase or decrease
value, press Option
to accept.
There are 40 ticks in one second.
TZ is trim zero, to TZ will zero the auto trims and copy
there values to the trim zero registers.
The auto trim function can only make changes of up to +- 12 percent.
Auto Trim
AT mode
Auto Trim
AT mode Inc
Use elevator stick to
toggle through all of
the selections. Press
Option to accept.

MSI 2000 Specifications

General

Brand	MSI
Model	2000
Category	Measuring Instruments
Language	English