6
MircoStar 2000
Version 1.1a
When power is first applied you will
see the following signon message for
about one second.
53.3 MHz
Accept? Yes(No)
Retracts are UP!
Press Option
10.5 RA--- 00:00
CUB
Transmitter battery voltage
On time, or down counter. The down counter
is started by pressing the Option button. The
timer will beep three times at 1 minute, twice
30 seconds, once at 10 seconds and every second
starting at 5 seconds.
Aircraft name
R indicates RF is on, only applies when my RF deck is used.
A indicate alternate aircraft is selected
These three dashed (---) indicate the status of the mixer
switches. If mixer number 2 is on your will see -M-.)
After a 1 second delay this retract warning will be displayed
if it has been enabled in the Options menu.
Option
The second line of the display will also show a message
any time a function switch is changed. For example if you
switch the aileron dual rate switch to low rate, the second line
will read “AIL D/R LOW” for about two seconds then
return to the aircraft name.
MicroStar startup
When my
RF deck is
used, this option
will allow you to
start up the transmitter
without any RF output.
To startup using a default setup, bypassing
the data in the configuration SPROM, press
the Auto Trim and Option buttons then
apply power. Wait 5 seconds then release
the Option and Auto Trim buttons.
165 RA--- 00:00
CUB
Pressing the Auto Trim button will change the battery
Voltage display to the total on time of the transmitter
in minutes.
Auto Trim
To Next Page
Loading...
Need help?
General