CHAPTER 4
AMI
®
BIOS USERS GUIDE
4-15
CPU Critical Temperature
This option is for setting the CPU temperature that would be critical
enough, so that it would use the Thermal Slow Clock Ratio to cool down the
CPU.
Power Button Function
During Suspend, if you push the switch once, the system goes into
suspend mode and if you push it more than 4 seconds, the system will be
turned off. During On/Off, the system will turn off once you push the
switch.
Restore on AC/Power Loss
The settings are power on or last status. During power on, after
every AC power loss, the system will be turned on. During last status, after
every AC power loss, whatever the system status, it will be the same when
the AC power returns.
Note: a. If you set this option to last status, the Power Button Function
must be set to On/Off, or this function will not work.
b. Jumper JP1 must always be open, for this function to work prop-
erly.
Ring Resume from Soft-Off
During Disabled, the system will ignore any incoming call from the
modem. During Enabled, the system will boot up if there’s an incoming call
from the modem.
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system. Then, power off the system. This
function will work the next time you power on.
To Next Page
Loading...
Need help?
General
