3. Select the pedal input you want to configure, either Pedal A or Pedal B.
4. Select Continuous from the Mode drop-down menu.
→ The pedal input is configured for a continuous pedal with expression behavior. If you need
to change the MIDI Control Change message assigned to the pedal input, refer to ↑8.4,
Using the MIDI Assignment Editor.
Depending on the type of pedal, you need to make further adjustments by using the provided
options. The following table gives you an overview of these options:
Option
Description
Invert toggle switch Some continuous pedals internally support the inverted pedal
range but cannot be configured on the pedal directly. The
Invert Range function allows you to invert the range of the
pedal connected to the keyboard.
Swap T/R toggle switch Allows you to use pedals with inverted tip/ring connectivity.
Recalibrate button Allows you to recalibrate the input.
Setting up KOMPLETE KONTROL
Connecting Pedals to the Keyboard
KOMPLETE KONTROL - Manual - 29
To Next Page
Loading...
Need help?
General
