1. Press and hold the REV mode button.
The track plays back reversely.
2. While holding the REV button, press and hold a Pad with a stored Hotcue.
The playback reversely continues from the stored Cue Point or Loop.
3. Release the REV button.
The playback resumes at the playhead position created by Flux mode.
Enabling Reverse mode also enables Flux mode.
7.12. Working with Mixer FX
A Mixer FX is a grouped effect which can be applied to the audio signal in the Mixer channel via
the Mixer FX Amount knob. You can choose between the FILTER Effect and one of four pre-selec-
ted Mixer FX using the FX SELECT buttons 1 to 4.
The following effects can be selected using the FX SELECT buttons:
FX SELECT buttons.
• FILTER: Selects the Filter effect. When selected, the button brightly lights up orange.
• FX SELECT 1: Selects the Reverb effect. When selected, the button brightly lights up red.
• FX SELECT 2: Selects the Dual Delay effect. When selected, the button brightly lights up
green.
• FX SELECT 2: Selects the Noise effect. When selected, the button brightly lights up blue.
• FX SELECT 4: Selects the Time Gater effect. When selected, the button brightly lights up yel-
low.
Tutorials
60
To Next Page
Need help?
General
