High and Low Limit Fields
The data placed in the High Limit and Low Limit reading fields can be either left-justified or
right-justified. However, all unused leading or trailing characters in the field must be spaces.
Example
Using the same example from the Manual Meter Review section, if the low reading limit is
equal to the previous reading, the value in the Low Limit field can be any of the following:
l Number of Dials = six...Low Limit = 001234 or 1234
l Number of Dials = five...Low Limit = 00123 or 123
l Number of Dials = four...Low Limit = 0012 or 12
The data in the High Limit field would need to be equivalent quantities:
l Number of Dials = six...High Limit = 001350 or 1350
l Number of Dials = five...High Limit = 00135 or 135
l Number of Dials = four...High Limit = 0013 or 13
High Limit Field Low Limit Field Test Results
Contains nines. Contains zeros. All readings pass the high / low test.
Contains all spaces. Contains all spaces. Handheld does not attempt the test for
that account.
Contents equals Low
Limit field.
Contents equals High
Limit field.
All readings pass the high / low test.
Table 11 – Disabling the High / Low
If the Number of Dials field contains incorrect data, the handheld attempts, but does not
complete, the high / low test for that account. The meter reader receives a warning.
R900
®
Belt Clip Transceiver Users' Guide 29
Appendix A: N_SIGHT
®
Meter Reading and Override
To Next Page
Loading...
Need help?
General
